dan h.

Forum Replies Created

Viewing 11 posts - 1 through 11 (of 11 total)
  • Author
    Posts
  • in reply to: Fracked Trout Habitat #45265
    dan h.
    Member

    I realize that this is focused on as a mostly environmental issue, but it seems like not disclosing the contents of the fracking fluid would be a clear cut safety violation.  

    Any workplace using chemicals is required to have an MSDS (Material Safety Data Sheet) on file and easily accessible to employees.  The MSDS is required to list any hazardous ingredients.  So isn’t not listing those a violation since the workers pumping them wouldn’t have that list?  I also have to believe that tank trucks must be regulated in some similar manner.

    I work in the food industry and know for a fact that if more than 5 gals of vegetable oil were to be spilled to storm water, we are required to report it.  So how can these toxic chemicals be INJECTED to aquifers and that not be a violation.  This is incomprehensible to me.

    in reply to: Minnesota/Wisconsin Trip Planning? #43289
    dan h.
    Member

    Your best bet for MN rivers while in Mpls starts a little over an hour south.

    in reply to: Fly Fishing Products Brainstorming Session #40483
    dan h.
    Member

    I’d like a rod that was 8 1/2 to 9 feet for casting and fishing which shrunk to 6 1/2 feet immediately upon hooking the fish for ease in fighitng and landing it.

    in reply to: River and Fishing Ethics #40117
    dan h.
    Member

    I believe a certain amount of rudeness, unethical behavior, whatever you want to call it, will always exist in any sizeable sample of the population.

    in reply to: Drive time to fishing grounds? #38810
    dan h.
    Member

    On a weekend – 45 mins to wild trout in a very nice little stream.

    in reply to: Where can I get my fix near Brainerd, MN? #38513
    dan h.
    Member

    Ryan, I don’t fish up there much and so don’t have the local knowledge to answer your question, but the MN DNR publishes a nice trout stream listing.

    in reply to: Next podcasts: Dr. Tom Whiting and Joe Tomelleri #38671
    dan h.
    Member

    I hope this one is as good as it promises to be – I’ve only been tying for a few years, but already the superiority of quality is evident.

    in reply to: Austria trip report #38129
    dan h.
    Member

    Cool trip!

    in reply to: Midcurrent Warranty Piece #37117
    dan h.
    Member

    The only rod I’ve ever broken is a St. Croix that broke at the butt ferrule on the male end.

    in reply to: Trailer Life #35260
    dan h.
    Member

    That TU trailer might be the best thing ever for Airstream.

    in reply to: Tippet selection #34105
    dan h.
    Member

    There’s a rule of thumb to divide the fly size by 3 and then round in the direction you want.

Viewing 11 posts - 1 through 11 (of 11 total)